Mavic AIR – Firmware 1.0.300

Overview
  • Date: 2018.03.21
  • Aircraft Firmware: v01.00.0300
  • Remote Controller Firmware: v01.00.0100
  • DJI GO 4 App iOS: v4.2.8
  • DJI GO 4 App Android: v4.2.8


What’s New?
  

  • Increased the descent speed to 3 m/s when flying forward.
  • Added support for operating at 5.8 GHz in Thailand.
  • Fixed an issue where the gimbal would drift when the aircraft’s heading changes.
  • Fixed an issue where the aircraft would shake when using ActiveTrack.
  • Added message if failure to take panoramas or an Asteroid QuickShot occurs (requires DJI GO 4 v4.2.8 and higher).
  • Fixed an issue where the remote controller was unable to link with the aircraft when operating in some regions.
  • Fixed an issue where the aircraft would fail to take a panorama in Sport mode or when APAS is enabled.
  • Fixed an issue where Intelligent Flight Battery firmware would not be updated when functioning abnormally.
  • Fixed an issue of video lag when the aircraft’s heading changes.
  • Fixed an issue of ghosting in photos.
  • Fixed an issue where the aircraft would fail to decelerate automatically when landing.


Notes:
  

  • Restart the aircraft and remote controller after the upgrade is complete.
  • Please note that the firmware update may reset various Main Controller Settings, such as the RTH Altitude and Maximum Flight Distance, to factory defaults. Before the update, take note of your preferred DJI GO 4 settings, and readjust them after the update to suit your preference.
  • This firmware update resets the camera settings.
  • If the firmware upgrade fails, restart aircraft, remote controller and DJI GO 4 or DJI Assistant 2, and retry.

Soyez le premier à commenter

Laisser un commentaire

Votre adresse de messagerie ne sera pas publiée.


*


*